User's Manual

Panorama™ Operating Instructions 0070-00-0575-50 5 - 39
Patient Setup Functions Print Setup Tab (Patient)
5.7 Print Setup Tab (Patient)
The Print Setup tab (FIGURE 5-25) is used to select the waveforms printed on a patient’s All
Strip, Event Zoom-In and Full Disclosure Zoom-In reports. The default settings for this tab are
determined by the System Settings. The layout and functionality of the Print Setup tab
changes based on the type of monitoring device assigned to the selected patient tile. The
fields discussed in this section may not apply to all users.
This section includes the following:
• Accessing the Print Setup Tab
• Adjusting a Patient’s Print Setup
• Sidebar Buttons
• Troubleshooting
5.7.1 Accessing the Print Setup Tab
1. From the menu bar, select the Patient Setup menu button. The tabs associated with
patient setup are displayed.
2. Select the Print Setup tab (FIGURE 5-25). The Print Setup tab is displayed.
FIGURE 5-25 Print Setup Tab
5.7.2 Adjusting a Patient’s Print Setup
This section outlines entering and modifying a patient’s print setup via the Print Setup tab.
Customizing a Patient’s Print Setup
1. Choose a patient tile by selecting its digital data or waveform area.
2. In the Print Setup tab, select a check box button to enable/disable the printing of a
parameter.The patient’s print setup settings are instantly changed.
The Parameters available in the Print Setup tab are dependent on the lead set and
monitoring device connected to the patient.
• A check mark in a parameter check box indicates that the parameter is selected and
will print in the patient’s All Strip report.
• An empty parameter check box indicates that the parameter is not selected and will
not print in the patient’s All Strip report.