User's Manual

NetGuard™ Operating Instructions 0070-10-0678-01 v
Warnings, Precautions and Notes Introduction
Cautions
CAUTION: For proper operation use only with UL agency approved
ethernet cables.
CAUTION: For proper operation, do not use the equipment with a
frayed or damaged power cord or ethernet cable.
CAUTION: Do not use a damaged or broken unit or accessory.
CAUTION: For proper operation never place fluids on top of the server.
In case of accidental spillage, wipe clean immediately and
have the system serviced to ensure no hazard exists.
CAUTION: The LEDs on the device may not be clearly visible under
brightly lit conditions. The lighting should be adjusted to
ensure that all LED indicators are clearly visible.
CAUTION: The server and terminal for this device must only be setup
by qualified Datascope personnel.
CAUTION: Do not block the terminal speakers. Set the volume levels to
ensure that alarms can be heard at all times.
CAUTION: Speaker volume should be set high enough to hear an
alarm above ambient noises.
CAUTION: The NetGuard device may not function properly, if it was
subjected to extreme mechanical forces.
CAUTION: To prevent the possible overlap of Trend data, a patient
should be discharged before another patient is admitted to
the same bed.
CAUTION: Discharging a patient should occur in the following order:
Discharge the patient from the bed, connect the device to the
new patient, and then assign the patient to a new bed.
CAUTION: The NetGuard device should not be used when the Electro
Surgical Unit (ESU) is active.
CAUTION: The NetGuard device may not function if the batteries
installed in the device are corroded.
CAUTION: Do not incinerate the NetGuard device. Possible explosion
may occur because of the internal battery.
CAUTION: To avoid possible interference with other facility devices,
use the correct AC cord for all equipment installed on the
NetGuard network.
CAUTION: It is recommended that password protected screen savers
be disabled after the NetGuard terminal software
installation. Use of screen savers may degrade the
performance of NetGuard software application.