User's Manual

Introduction Operations
5 - 12 0070-10-0678-01 NetGuard™ Operating Instructions
5.1.7 Editing Patient Information
Patient information can be changed after admission by accessing the Patient Edit form
(shown in FIGURE 5-11).
FIGURE 5-11 Patient Edit Form (Patient Level Alarms Enabled)
To edit an admitted patient’s information:
1. In the NetGuard Monitor view, select the applicable Monitor Group tab.
2. Select the patient’s bed.
3. In the Patient Detail form, select the Menu button.
4. In the Patient Menu form, select the Edit button.
5. Make the necessary changes in the Patient Edit form, and then select the OK button.
NOTE: The OK button is not enabled until a change is made in the
form.
6. Select the Yes button in the confirmation dialog box.
7. Optional - select the Close View button to close the form and return to the NetGuard
Monitor view.
NOTE: For alternative steps to accessing the Patient Edit form, refer
to “Accessing Monitor View Quick Menus” on page 5-15.