User's Manual

Introduction Operations
5 - 10 0070-10-0678-01 NetGuard™ Operating Instructions
5.1.6 Transferring Patient’s
Patient’s can be transferred to a room within the same Monitor Group or to new room in a
different Monitor Group by accessing the Transfer Patient form (shown in FIGURE 5-10).
The following gives instructions for performing both transfer types.
FIGURE 5-10 Transfer Patient Form (Patient Level Alarms Enabled)
5.1.6.1 Transferring Patient’s within a Monitor Group
Transferring a patient within a Monitor Group may be done by dragging and dropping or by
using the Transfer Patient form. Both methods are described in the following section.
To transfer an admitted patient within the same Monitor Group using drag and drop:
1. In the NetGuard Monitor view, select the applicable Monitor Group tab.
2. Left-click the patient bed to be transferred, and then drag it to another room in the
Monitor Group.
3. Select the Yes button in the confirmation dialog box.
The patient is now assigned to the new room.
To transfer an admitted patient within the same Monitor Group using the Transfer form:
1. In the NetGuard Monitor view, select the applicable Monitor Group tab.
2. Select the patient’s bed.
3. In the Patient Detail form, select the Menu button.
4. In the Patient Menu form, select the Transfer button.
5. In the Transfer Patient form, select the radio button labeled Within Monitor
Group, if necessary.
6. Select a destination bed from the list.
7. Select the OK button.