User's Manual

Operating Instructions NetGuard Device
2 - 4 0070-10-0678-01 NetGuard™ Operating Instructions
2.3 Operating Instructions
In addition to clinicians, the hospital personnel that routinely interact with the NetGuard
system include installers, IT specialists, administrative staff, and Datascope Field Service
technicians.
This section provides instructions for the hospital clinicians that apply the NetGuard device to
patient’s, monitor NetGuard display terminals, respond to alarms and perform first-line
troubleshooting.
2.3.1 Connecting the Device
To activate the device, insert the Reusable into the Disposable, as shown in FIGURE 2-3.
FIGURE 2-3 Connecting the Device
4.
Patient LED The patient LED turns green to indicate that the
patient’s heartbeat has been detected. When a lethal
physiological alarm condition is detected, the patient
LED flashes red.
5.
Battery Pack* The battery pack attaches to the transmitter pack and
powers the unit.
6.
Adhesive Patch* An elongated adhesive patch under the transmitter
pack contains two electrodes.
7.
Leadwire* A leadwire that interconnects the two adhesive patches
8.
V4 Patch* A second adhesive patch which should be positioned
at V4
* These four components make up the Disposable portion of the device
TABLE 2-1 (Continued)
NO. PART NAME DESCRIPTION
Reusable
Disposable