Operator`s manual

[15]
CES OPERATING INSTRUCTIONS
SETUP
To use the CES feature of the Delight Pro the unit must be powered from a
9V battery. If a 9-Volt adapter is plugged in, the CES will be disabled as a
safety precaution against electrical shock. Make sure to disconnect any
adapter before using CES.
The CES stimulus cable connects to the CES output jack ( ). Attach the
yellow clip to the left earlobe and the blue clip to the right earlobe. For
better conductance, it is recommended that you dampen the earlobe with a
small amount of water, saliva, saline solution or hair/electrode gel.
RUNNING CES
CES will only operate while an AVE session is running. The rate of stimulus
can either be synchronized with the AVE (default) or run at 100Hz. When
using CES by itself you can operate it while lying down or engaged in a
simple, non-hazardous activity such as walking, reading, or office work.
Follow the instructions for selecting a session (page 14). Once the session
has started, press CES button to start the CES pulses. The CES system
normally remains off and must be manually engaged every time you want to
use it. Turning down the stimulus level all the way will turn off the CES
system. The CES system can be turned on or off at any point during the
session.
The “L” and “R” LEDs (along the top edge of the panel) blink to indicate that
CES pulses are active. These LEDs blink at the CES stimulus rate. The
“100Hz” LED indicates that the CES is operating at 100Hz.
100HZ MODE
By default the CES stimulation is synchronized with the AVE stimulation in
the running session. When you first turn on CES, the rate of pulses will be
the same as the AVE frequency. To engage 100Hz mode at any time, press
both the CES and buttons together. Press them again to return to AVE
frequencies.
It is recommended that you engage 100Hz mode when the CES intensity is set
low, as the sensation from 100Hz stimulus is often much stronger than in AVE
Sync mode.