Operator`s manual

[14]
The Delight Pro
remembers which group
was used last, and each
group remembers which
session was used last.
AVE OPERATING INSTRUCTIONS
TURN ON/TURN OFF
Press and hold the Power button ( ) until the Power LED turns on. The
graph (between the VOL and INT controls) will display the battery level
when you first turn on the unit (see Battery Level). If no session is selected
within two (2) minutes, the Delight Pro will turn off.
At the end of a session, the lights and sound will fade out (Soft Off™) and the
Delight Pro will automatically turn off. To end a session early, press and
release the Power button ( ) to initiate a short Soft Off™ (30 seconds).
To turn off the Delight Pro at any time, press and hold the Power button
( ) until the unit turns off. This may take up to three (3) seconds if a
session is running.
BATTERY LEVEL
The battery level is displayed on the Graph for a couple of seconds when the
Delight Pro is first turned on. The battery level is also monitored and
displayed periodically while the session is running.
When the battery level is getting low, the Graph will display two (2) blinking
bars. It is recommended that you replace the battery before running a
session if this warning is displayed.
When the battery level is critically low, the Graph will display a single (1)
blinking bar. If this warning is displayed when you turn the unit on, replace
the battery. If this warning occurs during a session, the session will end
early and the battery indicator will continue to blink for a short period of
time. The battery must be replaced before the unit can be used again.
SELECTING A SESSION
The Delight Pro has six (6) Session groups ( , , , , , ). Each group
offers five (5) sessions. The session number is indicated by the lit number
between the volume and intensity controls. If no number is lit then the
group has no session programmed into it.
Press and release the Power button ( ) to
switch between groups. The lit group icon will
change. Press the Volume or Intensity or
to highlight a session number. If no sessions are
available in a group, no numbers will be lit.
Press to start the selected session. The session will begin after a five (5)
second delay.