Operator`s manual

[13]
AVE OPERATING INSTRUCTIONS
SETUP
The headphones connect to the headphone output jack ( ). When using an
Extra User Package (sold separately), connect the 3.5mm splitter cable to the
Delight Pro and connect each set of headphones to the splitter cable. It is
recommended that you disconnect the headphones from the unit before
storing or travelling to prevent accidental damage to the jack.
The Tru-Vu Omniscreen, Tru-Vu Omniscreen Viewhole, or Tru-Vu
Omniscreen Multi-Color Eyeset connect to the eyeset output jack ( )
with the included 2.5mm patch cord. Connect one end to the Delight Pro and
the other to the jack located on the lower left of the glasses. When using an
Extra User Package (sold separately), connect the 2.5mm splitter cable to the
Delight Pro and connect each eyeset to the splitter cable. It is recommended
that you disconnect the eyeset cable from the device and from the eyeset
before storing or travelling to prevent accidental damage to the jacks.
An external audio source (such as an MP3 or CD player) can be connected to
the Delight Pro so that music or other audio can be listened to while running
a session. Plug the stereo patch cord into the headphone output of the audio
) of the Delight Pro. Note: start the device and the audio input jack (
Delight Pro and select a session before playing audio unless you would like to
run a Sound Sync Session (see page 20).
POWER
The Delight Pro can be powered with a 9-volt alkaline or rechargeable
battery, or with the 9-Volt adapter provided. To install the battery, slide the
cover off of the battery compartment on the back of the unit. Insert a 9-volt
battery as indicated on the diagram in the battery compartment. Slide the
cover back into place. An alkaline 9-volt battery will provide approximately
seven (7) hours of operation
To use the 9-Volt adapter, connect the adapter to the 9-Volt jack ( ) on
the side of the unit. The 9-Volt DC power adapter uses a 1.3mm center-
positive plug. No battery power is used when plugged into an adapter.
Note: to prevent accidental shock the CES capabilities will be disabled when a
power adapter is connected. To use the CES functions disconnect the adapter
and run from battery power only.