Datasheet
37
Introduction
Design
Guide
Polyimide
Heaters
Silicone
Rubber
Heaters (foil)
Standard
Polyimide
& Rubber
Rubber
Heaters
(wire-wound)
Mica Heaters
Thermal-Clear
Heaters
All-Polyimide
Heaters
Sensors,
Controllers &
Accessories
Reference
Sal es and Support
Americas: 763.571.3121 | Europe: (33) 5 61 03 24 01 | Asia Pacic: (65) 6511 3388
|
Specifications subject to change
Dimensions shown in inches (mm)
Additional options for CT16A (board level)
924: Analog remote setpoint: (0 to 10 VDC) Vary the setpoint
using a voltage signal.
926: Analog remote setpoint: (4 to 20 mADC) Vary the set-
point using a current signal.
928: Analog remote setpoint: (0 to10,000 Ω) Vary the setpoint
using a potentiometer.
934: Analog retransmission of Process Variable or Set
Variable: (4 to 20 mADC) For use as recorder, transmitter or
computer A/D input. Linearized 4 to 20 mA DC signal follows
the Process or Set variable. Scalable.
936: Analog retransmission of Process Variable or Set
Variable: (0 to 10 VDC) Similar to option 934, but output signal
is linearized 0 to 10 VDC.
948: 4-Stage setpoint: Four preset setpoints may be selected
by external contacts. Each set point has its own set of PID
values giving controller 4 distinct “recipes” for different process
situations.
992: RS-485 Computer communication link: Allows remote
computer to read and write all control parameters.
993: RS-232 Computer communication link: Allows remote
computer to read and write all control parameters.
Accessories
AC744: 1-10 A, 24 to 280 VAC SSR
AC745: 1-25 A, 24 to 280 VAC SSR
AC746: 1-50 A, 24 to 280 VAC SSR
AC1009: 1-20 A, 0 to 100 VDC SSR
AC743: SSR heat sink for high current or ambient temperature
AC996 R/C Snubber: Highly recommended to prolong relay
contact life if using the mechanical relay or SSR output to drive
a relay or solenoid. Also, for the CT16A AC SSR output, make
sure that the coil HOLDING current is greater than 100 mA and
voltage is minimum 48 VDC.
AC1001: Steel 1/16 to ¼ DIN adapter plate. 127×127 mm gray
steel with 45×45 mm centered hole.
1.76
(44.7)
0.45 (12)
1.89
(48)
1.89
(48)
PANEL CUTOUT: 1.775" × 1.775" (45 mm × 45 mm)
MAXIMUM PANEL THICKNESS: 0.25" (6.35 mm)
5.04 (128)
AC743
AC1001
AC996
CT16A Temperature Controller