Datasheet

Specifications
Temperature range: -55 to 120°C (-67 to 248°F).
Insulation: Optical grade polyester is standard. Glass and
polycarbonate materials are available on custom models.
Transparency: 82% minimum light transmission over the
visible spectrum.
Heating element: Resistive wire, diameter 0.0008" to 0.002"
(0.02 to 0.05 mm).
Resistance tolerance: ±10% or ±0.5 Ω, whichever is greater.
Leadwires: PTFE insulated wire is standard. Lead connections
are welded and anchored between heater layers for strength.
Special terminations are available on custom models.
Heaterstat™ Sensorless Temperature Controller
Any Thermal-Clear heater will work with the CT198 Heaterstat™
Sensorless Temperature Controller, which directly regulates
element temperature without requiring a separate sensor.
See the "Sensors and Controllers" section for full specifications
and compatibility.
23
Introduction
Design
Guide
Polyimide
Heaters
Silicone
Rubber
Heaters (foil)
Standard
Polyimide
& Rubber
Rubber
Heaters
(wire-wound)
Mica Heaters
Thermal-Clear
Heaters
All-Polyimide
Heaters
Sensors,
Controllers &
Accessories
Reference
Sal es and Support
Americas: 763.571.3121 | Europe: (33) 5 61 03 24 01 | Asia Pacic: (65) 6511 3388
|
Specifications subject to change
Thermal-Clear™ Transparent Heaters
Y
X
12"
(300 mm)
MAX. THICKNESS
OVER ELEMENT:
0.010" (0.25 mm)
OVER LEADS:
0.070" (1.8 mm)
DIMENSIONAL TOLERANCE:
6" (150 mm) or less:
6.01 - 12" (150 - 300 mm):
±0.03" (±0.8 mm)
±0.06" (±1.5 mm)
MAX. LEAD BULGE:
0.42" WIDE x 0.35" DEEP
(11 X 9 mm)