User's Manual

Product Requirement Specification
Mimosa Confidential Page 17
3.9 LED Indicators
The functions of each LED shall be implemented in software. The table below
defines the functions of each LED.
LEDs Description – 3 LEDs
NOTE: No LEDs on the RJ-45 Ethernet connectors
Wi-Fi
Router
Wi-Fi
Extender
Range
Extender
Pass-
through
WAN
(green/red)
Link on RJ45
WAN
C5 CPE status
Green
Yellow
Red
Green On: Good Link on 1000Mbps Y
WAN
LED
OFF
WAN
LED
OFF
Y
Yellow On: Good Link on 100Mbps Y Y
Red On: Good Link on 10Mbps
(this is red because a 10Mbps link is not
desired)
Y Y
Red Blinking: C5 CPE Dead or no connectivity Y Y
Off: Power Off Y Y
LAN
(green/red)
Link on R45
LAN
Green
Yellow
Green On: Good Link on 1000Mbps Y Y Y Y
Yellow On: Good Link on 10/100Mbps Y Y Y Y
Off: No Link Y Y Y Y
Note: No Red status for 10Mbps as this is
acceptable and could be confused as error.
Wi-Fi
(blue)
Link on 11n
2.4G Wi-Fi
Blue
Blue On: Wi-Fi has at lease one client
connected.
Y Y Y
Wi-Fi
LED
OFF
Off: Wi-Fi is disabled or no client is
connected.
Y Y Y
System Status
During Boot
System Initialization or reset (software self-test and loading):
Cycle –blink green and red on WAN; blink green and yellow on LAN Wi-Fi Off
System Boot Failure:
Blink Red on WAN and blink yellow on LAN, Wi-Fi Off
3.9.1 LED Locations
ʔ
See Detailed LED placement from CAD Mechanical Drawings
ʔ
NOTE: There are no LED’s on the Ethernet RJ-45 connectors.