User's Manual

WiFi Console
WARNING: If you turn of the 2.4 GHz management, you must have an in-
band method of accessing your device. If you have turned off your 2.4 GHz
management and are now unable to access your device, you may always
access your device via your Recovery SSID.
To do this, unplug the device's ethernet cable connection. Then, unplug the
PoE (Power over Ethernet) and plug the PoE back in to cycle power. The
recovery SSID will now be broadcast and must be accessed within 2
minutes, after which the 2.4 GHz management will be disabled again.
Once you are connected to the 2.4 GHz management system, type
http://recovery.mimosa.com into your browser to reach the interface.
After you have managed the device through the Recovery mode,
reconnect the device's ethernet cable.
Network Mode
Local
Management
SSID
Recovery SSID
Key (ASCII
passphrase)
Maximum
wireless clients
Enable or Disable the 2.4 GHz management network. You
can also set the mode to auto enable/disable. This mode
turns the 2.4 GHz management system on for a limited time
(2 minutes) when the device is being booted and then turns
of.
The SSID name for the 2.4 GHz local management
interface.
This SSID is fixed as a fallback recovery of the device
management system.
Enter a passphrase to generate a WPA2-PSK key for
securing the 2.4GHz 802.11 management interface
Assign the maximum number of wireless clients that can
access the 2.4GHz 802.11 management interface
(simultaneously associated).
Administration 19