User's Manual

Mimosa Help Site

Mimosa Networks Help Site Channel & Power

Managing Channel & Power Settings

The Chanel and Power Settings panel allows for either automatic or manual changes to frequency, channel width,

and power for either one or two channels.

Auto Everything - Automatically configure channel, channel width and power to optimize performance based on

●

spectrum data.

Channel Width (MHz) - Choose the width for each (20, 40, 0r 80 MHz).

●

Channel Center Frequency - In Off (Manual) mode, select the center frequency of the channel used on the link.

●

In all modes, the center frequency represents the absolute center of the selected channel width without any

offset, and the center can be moved in 5 MHz increments. If Auto Everything is set to On, the Channel(s) will be

automatically set, and not editable.

Power - Set the desired transmit power level. The allowed options are determined by a combination of country

●

and chosen frequency. If Auto Everything is set to On, the Channel & power will be automatically set, and not

editable.

Antenna Gain (dBi) - Set the gain according to antenna specifications and subtract out any cable/connector

●

loss. By default, this value is set to 25 dBi for the B5 and not shown.

Channel Recommendations - List of channel widths, center frequencies, and Tx powers that Auto Everything

●

would choose in order of preference (if enabled).

Note: Tx power selections may be limited based on your regulatory domain (refer to the Maximum Power chart for more details).