Product Manual
Table Of Contents
- Abbreviations And Acronyms
- 1 Tornado System Overview
- 2 Safety Warnings
- 3 Tornado radio unit overview
- 4 Setting Up on the Bench
- 5 Configuration Control and Monitoring System (CCMS)
- 6 Changing Operating Frequency and Power Calibration
- 7 Duplexer Tuning Guide
- 8 Radio Reference Information
© MiMOMax Wireless Ltd
Tornado Product Manual
24
6.5 POWER CALIBRATION
The process for calibrating the transmitter power is described below. The process for calibrating the power using CCMS is
different from the process when using CLi in terms of what users can do. It is also a subject to constraints that the UI poses
on the user. First select the TX Power Calibration from Calibration at the main menu. When done the following control is
shown:
Press start to initiate the power calibration.
Proceed with Cal Tx1 to calibrate the 1st transmitter or with Cal Tx2 to do the 2nd one. The order isn't important. The power
at the current state is down and the carrier is turned On once one of these buttons is pressed.
6.5.1 Calibrating Tx (Coarse Step)
Once we press Cal Tx1 the carrier power is turned On for transmitter 1 (transmitter 2 is Off) and user is ready to measure
output power (uncalibrated output). The following page will allow to input the measured power and perform the 1st step of
calibration (the coarse step),
During this step the duplexer loss in the RF EEPROM will be adjusted once Calibrate is pressed. This click will take the user
to the 2nd calibration step, called the fine step.