Product Manual
Table Of Contents
- Abbreviations And Acronyms
- 1 Tornado System Overview
- 2 Safety Warnings
- 3 Tornado radio unit overview
- 4 Setting Up on the Bench
- 5 Configuration Control and Monitoring System (CCMS)
- 6 Changing Operating Frequency and Power Calibration
- 7 Duplexer Tuning Guide
- 8 Radio Reference Information
© MiMOMax Wireless Ltd
Tornado Product Manual
23
Simply enter the new TX and Rx Frequencies and/or desired power. Enter save and follow the on screen instructions. The
next page is shown below.
A warning appears that requests that the duplexers be retuned and the unit rebooted. This warning will appear on all CCMS
pages, and the transmitters will be shut down, until the unit is rebooted.
Configure RF CCMS Page
Once the unit has been rebooted a new warning will appear. It will warn that power calibration is required. Power Calibration
should be performed only after Channel 1 and 2 duplexers have been retuned. Ensure that you connect your power meter to
the Channel 1 Transmitter then select the Calibration link. Navigate through the drop down menu to TX Power Calibration.
The Channel 1 transmitter will turn on immediately when entering the TX Power Calibration Screen so it is important to already
have the power meter connected.
Enter New Frequencies Page