User manual

MIMO 2x2 Wireless Outdoor Access Point System User Manual
15
Figure 7. Internet Protocol Properties
2.2 Check access to the unit
Use Ping utility of DOS mode to check the access to the outdoor unit.
1) Go to DOS mode
2) Enter the command:
ping 192.168.100.20
The outdoor unit shall respond your ping request.
Note that use the same PC to ping different outdoor units may cause ping failure. This is because the all of
the outdoor units share the same default IP address but different MAC addresses. To prevent from ping failure, you
need type command arp –d to clear ARP table on PC before each ping.