User guide

Page 22 of 49
2.4 Basic Configuration
2.4.1 System Setting
This page can be access by clicking “System -> Setting” from left side menu.
Figure 12 System Setting Page
1) IP Address / Subnet Mask / Gateway
Note that each AP/Bridge unit in the same network must be assigned an
unique IP address. So, you may need to have a network plan before
deployment. Enter the IP address, Subnet Mask and Gateway Address
according to the planning. If there is no gateway in the network, you may
leave it in blank. IP Address / Subnet Mask / Gateway change will be
immediately applied right after clicking “Save” button.
2) Password
Change Password by typing new password, and confirm new password, and
clicking “Save” button. User will be asked to login again use new password