Specifications

- 38 -
Setting-Up mimio classic for Windows
4. Unpack the box and check that you have all of the components listed.
5.
Install the supplied batteries and marker pens in the styli cases and supplied battery in
the
eraser. You do this as follows:
a.
Pens-remove the clear plastic cover by pressing the end of the pen. Remove the
green switch cover by lifting the cover at the nib end and slide down. Insert one
AAA battery and replace the switch cover. Insert the corresponding colour marker
to the styli case. Replace the clear plastic cover. Do this for all 4 pens.
b.
Eraser-remove the top cover by pressing the sides close to the thin felt pad. Insert
one AAA battery and replace the top cover.
6.
Load the operating software onto your PC. If your PC does not auto start the set-up
program after placing the
CD in your CD-ROM drive press Start/Run type D:\setup.exe
(enter) in the Run dialogue box (where D:\ is the location of your CD-ROM drive). Then
follow the onscreen instructions.
7.
Attach the capture bar to the top left hand corner of your whiteboard. Ensure that the 2
hinged flaps are out. Press the bar firmly to the board and close both flaps-you will hear an
audible click. (The flaps pull the suction cups upwards creating a strong ‘vacuum’
adhesion)
8. Connect the capture bar to your PC using the supplied serial cable.
NOTE: You must connect the PS2 mouse pass through connector as well as the serial
connector- this draws power to the bar.
Open the mimio program on your PC