Specifications

- 13 -
Getting Started (cont’d.)
Settings - Page
The mimio software will automatically capture all notes, diagrams and drawings on any hard,
flat, smooth surface up to a 4’ x 8’ (1.2m x 2.4m) area in size. If you would like to adjust the size
of the virtual whiteboard in the software so that it proportionally matches the actual whiteboard
in use, simply go to Settings-Page.
Under Settings-Page (located on the main menu bar at the top or at the far left), if you know the
size of your board, simply check the appropriate size and click
OK.
If you don’t know the size of your board click
Auto Size and click with any mimio stylus pen in
the lower right-hand corner of the whiteboard. The mimio software automatically sizes to the
board you are using.
You can also custom size your board by checking the
Custom box and adjusting the sliders at
the side and bottom of the graphic box.
Note: If your whiteboard is portrait oriented (meaning it is taller but not wider than 4’ (1.2m),
remember to go to
Page-Hardware and select the horizontal mimio bar orientation.