Specifications
3-16
Setting the adsorbing level
Set when you want to change the adsorbing level. (Supported from the firmware ver.1.80)
1
When <LOCAL> is displayed, press the
key.
2
Press the key.
3
Select the type 1 to 4 with the
key, and press the key.
4
Select the [VACUUM] with the
key, and press the key.
5
Select the adsorbing level with the
key, and press the key.
6
Press the key to finish.
Item Outline
STRONG Adsorbing level is strong.
STANDARD Adsorbing level is standard.
WEAK Adsorbing level is low.
OFF The media does not adsorbing.
<LOCAL . 1>
FUNCTION
FUNCT I ON
SET UP <ENT>
ENTER
SET UP
SELECT : TYPE1
ENTER
[1]
VACUUM <e n t >
ENTER
[1]VACUUM
SETUP : STANDARD
ENTER
END