Specifications

Setting the print condition
3-8
Setting list
The settings of the print condition are as follows. The underlined has been set as default.
These settings can be registered on the “Type”.
Item Setting Outline
MEDIA COMP( P.3-9) -9999 to 0 to 9999
Prints the pattern to adjust the media
feed.
MediaFeed SETUP
(
P.3-12)
FEED
METHOD
NORMAL
/
DIRECT
Sets about media feed.
HEATER
(
P.3 -11 )
SET
TEMP
Pre-Heater
OFF
/ 20 ~ 50°C
(OFF/ 68 ~ 122°F)
Sets heater conditions.
Print Heater
OFF
/ 20 ~ 50°C
(OFF/ 68 ~ 122°F)
PRINT
MODE
(
P.3-13)
QUALITY
STANDARD
/
FINE/FAST
Sets the drawing quality and the draw-
ing direction.
SCAN
DIRECTION
Bi-D/Uni-D
LOGICAL
SEEK
PICTURE
/OFF
WhiteLayer-
Print
ON/OFF
UV LEVEL( P.3-15)
HIGH/STANDARD
/
LOW/NONE/
NO PRINT
Sets the UV light intensity.
UV SCAN ADD 0
to 9
Adds the number of UV scanning that
cures ink by irradiating UV to the end of
the image after drawing.
INK LAYERS 1 to 9 Prints with layers.
MARGIN
LEFT -10 to 0
to 85
Sets the margin on the both sides of the
media.
RIGHT -10 to 0
to 85
REFRESH LEVEL 0, 1
, 2, 3
Refreshes the ink head during drawing
or in a standby.
VACUUM(
P. 3- 16 )
OFF/WEAK/
STANDARD/
STRONG
Sets the adsorbing level for the media.
(Supported from the firmware ver.1.80)
PRIORITY(
P.3-17) HOST/PLOT
Sets the priority between PRINT MODE
and INK LAYERS.
MEDIA DETECT
DETECT
METHOD
SELECT
/WIDTH Sets the way of media detection.
MEDIA
WIDTH
AUTO
/
210 to 1620mm
Sets the media width. ( P.3-18)
(Supported from the firmware ver.2.00)
SETUP RESET(
P.3-19) - Resets the settings.