Specifications

2-30
Preparing Heaters
Set the heater temperature according to the media used.
Changing temperature settings of the heater
The temperature of the heater can be changed by [HEATER] of the setup mode.
( P.3-11 "Changing the heater temperature setting")
• When purchased, the heater temperature is set "OFF".
• Since the temperature can be adjusted in drawing, you can set the proper temperature.
• Depending on the environmental temperature, it may take several minutes to several ten minutes to
reach the set temperature.
1
When <LOCAL> is displayed, press the
key.
2
Press the key.
3
Set the each temperature of the heater
with the keys, and
press the key.
• Select the heater with the keys.
• Set the temperature with the keys.
4
Heating of the heater starts.
• The [HEAT] lamp lights in orange.
5
Heating ends.
• When the heater reaches the set temperature, the [HEAT] lamp goes out, then the
[CONSTANT] lamp lights in green.
6
Press the key to finish.
<LOCAL. 1>
HEATER
PRE PRT
35°C 40°C
Heater temperature
confirming display
HEATER
4 0 °C 40 °C
(OFF OFF )
The set temperature ： 20 to 50°C
Temperature set in [HEATER]
of each type in the [SET UP].
ENTER
ENTER