Specifications

2-13
Setting media
2
Basic Operations
11
Prepare the take-up device.
• Set an empty core to the take-up device.
12
Press the key to select “ROLL” .
• The media width is detected.
13
Fix the media on the take-up device.
( 1 ) Feed the media up to the core of the take-up
device with the key.
( 2 ) Fix the center of the media with adhesive tape.
( 3 ) Fix the left and right side of the media in the
same way.
• Pull the right and the left of the roll media evenly,
make sure that there is no slack or wrinkle on the
media, and then stick the tape.
14
Adjust the head height.
• Adjust the head height according to the media thickness. ( P.2-24)
• When a space between the media and the head is wide, a
screen shown on the right is displayed and the media cannot
be detected.
In this case, lower the head height. ( P.2-24)
Core
Take-up device
MED I A SE L ECT
ROL L < > L EAF
ERROR 50
WI DTH