Specifications

1-5
Configuration and Function
1
Before Use
Rear/ Side of the main power switch
USB Connector
USB2.0-compliant interface connector.
Roll holder
Set on both sides of the core of the
roll media to hold the media.
Supports the cores of 2 inch and 3
inch.
Clamp Lever (Rear)
Interlocked with the Clamp
Lever (side).
Main Power Switch 1
Turns on/off the power of this machine
(except UV LED).
AC Inlet (Inlet 1)
Connects the power cable.
Voltage selector switch
Switches 100 to 120V and 200 to 240V
depending on the supply voltage using this
machine. To avoid damage of this machine by
incorrect setting, do not touch this switch
except in the installation.
Water
Heating Device
Keeps the ink at a
proper temperature.
Pre-Heater
Preheats the media before printing.
(Located inside the platen)
Main Power Switch 2
Turns on/off with the main power
switch 1.
AC Inlet (Inlet 2)
Connects the UV LED unit.