Specifications
Table Of Contents
- TABLE OF CONTENTS
- CAUTION
- Foreword
- For safe operation
- How to Read This Operation Manual
- CHAPTER 1 Before Use
- CHAPTER 2 Basic Operations
- CHAPTER 3 Useful Function
- Changing origin
- Adjusting head gap
- When nozzles missing can not be improved
- Setting the print condition in a set
- Setting the print condition
- Setting media compensation
- Setting the print method
- Registering head gap value
- Set the scan width of the head
- Changing the UV illumination intensity
- Sets UV irradiation at starting/ ending of drawing
- Setting the priority
- Sets the cooling time per scan
- Initializing the settings
- Turning OFF the UV lamp
- Setting the UV lamp OFF duration
- Changing the UV illumination intensity
- MACHINE SETUP
- Other useful functions
- CHAPTER 4 How to care
- Maintaining
- Ink cartridge
- Washing cartridge
- Cleaning the flushing box
- Avoiding ink dripping at printing
- When the waste ink tray is full
- Setting nozzle face cleaning time
- Perform cleaning automatically when the power supply is turned on
- Preventing nozzle dropout while power-off
- Regular maintenance of white ink
- If blur or missing remains
- Wiper cleaning
- Refill antifreeze liquid
- Cleaning of the UV lamp filter
- Cleaning of the UV power supply filter
- Cleaning of the optional vacuum unit filter
- Replacing the mist fan filter
- Replacing UV lamp
- Checking method of UV illumination intensity
- Cleaning of the Ionizer
- Prevent the nozzle clogging of spot color
- CHAPTER 5 In Case of Trouble
- CHAPTER 6 Appendix
2-19
Drawing an image from data
2
Basic Operations
Cancelling the drawing
To stop the drawing, stop the drawing operation and erase the received data from this machine.
1
Press the key while drawing.
• Drawing operation stops.
• When a data is being sent from the computer, stop
sending data from the computer.
2
Press the key.
3
Press the key.
• Received data is cleared and <LOCAL> is dis-
played.
When drawing stops
If the following error or warning appears during drawing, the machine stops drawing and returns to the local
mode.
Press the key in the local mode to restart drawing.
Message Cause Solution
• The carriage detected an obstacle. • Remove the obstacle on the table.
*1
*1. For some detecting conditions, the machine finishes drawing and performs initial operation.
• The area sensor detected an
obstacle.
• When an obstacle was detected,
the table automatically lowers to
avoid it.
Head gap is changed.
Remove the obstacle and check
head gap again. ( P.3-5)
• The front cover is open. • Close the front cover.
*REMOTE. 1*
REMOTE
<LOCAL . 1>
DATA CLEAR
DATA CLEAR
<ENT>
ENTER
REMOTE
ERROR 54
MED I A JAM
ERROR 36
HEAD GAP
!FRONT COVER OPEN