Specifications
Table Of Contents
- TABLE OF CONTENTS
- CAUTION
- Foreword
- For safe operation
- How to Read This Operation Manual
- CHAPTER 1 Before Use
- CHAPTER 2 Basic Operations
- CHAPTER 3 Useful Function
- Changing origin
- Adjusting head gap
- When nozzles missing can not be improved
- Setting the print condition in a set
- Setting the print condition
- Setting media compensation
- Setting the print method
- Registering head gap value
- Set the scan width of the head
- Changing the UV illumination intensity
- Sets UV irradiation at starting/ ending of drawing
- Setting the priority
- Sets the cooling time per scan
- Initializing the settings
- Turning OFF the UV lamp
- Setting the UV lamp OFF duration
- Changing the UV illumination intensity
- MACHINE SETUP
- Other useful functions
- CHAPTER 4 How to care
- Maintaining
- Ink cartridge
- Washing cartridge
- Cleaning the flushing box
- Avoiding ink dripping at printing
- When the waste ink tray is full
- Setting nozzle face cleaning time
- Perform cleaning automatically when the power supply is turned on
- Preventing nozzle dropout while power-off
- Regular maintenance of white ink
- If blur or missing remains
- Wiper cleaning
- Refill antifreeze liquid
- Cleaning of the UV lamp filter
- Cleaning of the UV power supply filter
- Cleaning of the optional vacuum unit filter
- Replacing the mist fan filter
- Replacing UV lamp
- Checking method of UV illumination intensity
- Cleaning of the Ionizer
- Prevent the nozzle clogging of spot color
- CHAPTER 5 In Case of Trouble
- CHAPTER 6 Appendix
2-11
2
Basic Operations
Setting media
For this machine, you can use the media of 150 mm thickness or below.
For the media to be used, refer to P.1-16 "Usable media size".
1
Set the media.
2
Pressing the key, absorb the media to the table.
• In the inkjet printer, ink drops tend to turn into mist when the gap between head and media is set wider
than 2mm because of the insurmountable length. The more the gap get wider, the more likely it occurs.
The mist of ink adheres to the head surface and the filter of the cooling fan. Also, the reflection from the
UV light becomes higher. In case the adhered ink is cured or get sticky by the UV light reflection, it
causes nozzle clogging and mismatched ink position. Sometimes it may be necessary to replace the
head due to the failure.
• If, within the absorption area, there are suction holes not closed by the media, close such suction holes
placing thin sheet form material such as paper, film or tape.
• The peripheral parts of the media could roll up due to heat. Fix the media supplementarily using
adhesive tapes, etc.
After setting the media, set the followings.
• Register the head gap. ( P.3-16)
• Check the head gap. ( P.3-5)
VACUUM