Specifications

Regular maintenance for white ink

4-31

Maintenance

Slowly shake the white ink cartridge more than twenty times right and left.

• To prevent ink from leaking when you shake the cartridge, wear gloves and firmly cover the A part of the

upper surface of the cartridge and the B part of the bottom surface of the cartridge with paper towels.

Then, shake it more than twenty times right and left so that ink flows inside the cartridge.

When a screen shown in the right is displayed,

return the two white ink cartridges to the ink station.

• As shown in the drawing, set an ink cartridge turning up a side

containing the IC chip.

• When the two white ink cartridges are set, white ink filling

starts. (When the ink set is “W CL”, set the white ink cartridge

and the clear ink cartridge.)

When a message shown in the right is displayed

after completion of white ink filling, press the

key to finish.

• If you shake it too strong, the pack inside may be damaged and it may cause ink leakage. Therefore,

perform this carefully.

• If the remaining amount of ink is less, ink in the cartridge cannot be beaten enough. Tilt the cartridge

until it becomes vertical.

Part A

(Insertion hole of the needle)

Part B

(Gap on the bottom surface)

Cover with paper towel

firmly and shake ink slowly

Repeat this

A part

WHITE MAINTAIN

SET CARTR I DGE

IC chip

FILLING UP INK

PLEASE WA I T

MA I NT ENANCE

WHITE MAINTAIN <ent>

END