Specifications

3-13
Various settings
3
Useful Function
Setting the mode of the LED UV
The mode of the LED UV may be set in 3 stages.
This setting is made when the media vulnerable to the heat is used or when the test drawing is made in which the
lighting of the LED UV is not desired.
1
Press the key in the local
mode.
2
Select the [SET UP] by pressing the or
key, and press the key.
3
Select the [UV MODE] by pressing the or
key, and press the key.
4
Press or keys to select the mode, and
press the key.
• Set values :ON , OFF , NOPRINT
5
Press the key several times to end the setting.
ON The LED UV is lit.
OFF The LED UV is not lit.
NOPRINT
The drawing is not performed and only the LED UV is lit. Use when drawing is performed without the LED
UV is lit etc., and when you wish to make it cure afterward. (Normally, this setting will not be made.)
• The mode of the LED UV may be set on the RIP side, when performing the remote drawing. For details,
please refer to the Instruction Manual of your RIP.
<LOCAL>
FUNCTION
FUNCT I ON
WOR K S E T < E N T >
ENTER
SET UP
UV MODE < e n t >
ENTER
SET UP
UV MODE : ON
ENTER
END