Specifications

2-9
Drawing an image from source data
2
Basic Operations
Interruption of drawing
To interrupt drawing, stop the drawing operation and erase the received data from the machine.
1
Press the key while drawing.
• Drawing operation stops.
• When data is transmitted from the computer, the computer
stops transmission of data.
2
Press the key.
3
Press the key.
• Received data is erased and the machine returns to the local
mode. Y-bar moves to the evacuation position.
When [! WORK High] is displayed
When [! WORK High] is displayed on the screen and the drawing operation
stops during drawing, restart drawing with the procedures below:
1
Press the key.
• The screen returns to LOCAL.
2
Check the media setting status, and press the key.
• The machine restarts drawing.
• If you do not wish to restart drawing, press the key to interrupt drawing.
( P.2-9 “Interruption of drawing”)
• To restart drawing, press the key again.
• During drawing, the sensor always monitors the media height. When the gap check function ( P.3-7)
is set to “OFF”, if the sensor detects the media, the drawing operation is interrupted automatically, and [!
WORK High] is displayed on the screen.
<LOCAL>
REMOTE
REMOTE
DATA CLEAR
<ENT>
DATACLEAR
** DATA CLEAR **
ENTER
ERROR 5 0 5
!WORK H i gh
<LOCAL>
ENTER
REMOTE
DATACLEAR