Specifications

2-4
Setting the media
1
Open the table front cover.
2
Set media along the L-shaped mark (drawing
origin) on the right corner of the table.
• To change the drawing origin, see the following page.
( P.3-2 "Changing origin")
• To use tools, set into the shaves (8.0 mm-deep) on the corners
of the table.
3
Close the table front cover, and press the key.
• The origin is detected. Please wait until the operation is finished.
4
Press the key depending on the
intended use.
• The media is fixed.
To avoid media lifting, be sure to turn ON the vacuum fan if
using thin media.
5
Adjust the table to an appropriate height for drawing by pressing the
TABLE keys, and press the key.
• To avoid lifting of media, turn ON the adsorption fan after setting media.
• If, within the adsorption area, there are suction holes not closed by the media, close such suction holes
placing thin sheet form material such as paper, film or tape.
• The peripheral parts of the media could roll up due to heat. Fix the media supplementarily using
adhesive tapes, etc.
• Adjust the height of the table with the media to 50 mm or less.
ENTER
Adsorption
area
VACUUM
ENTER