Instruction manual

- 3.10 -
Returning speed up [RET. SPD UP]
In case the printing width is 1000mm or less when uni-directional printing, the nozzle drop out
may occur. Using this function to slow down the returning head speed may solve the trouble.
ON : The head returns with normal speed.
OFF : The head returns with slow speed.
STEPS:
1. Select a type. (see page 3.3)
Here, select [Type.1].
2. Press the [ENTER ] key.
3. Press the JOG keys [
] and [ ] to select
[PRINT MODE].
4. Press the [ENTER] key.
5. Press the JOG keys [
] and [ ] to select
[RET.SPD UP] .
6. Press the [ENTER] key.
7. Press the JOG keys [
] and [ ] to set a return-
ing speed [ON] or [OFF].
Here, select [OFF].
8. Press the [ENTER] key.
9. Press the [END] key three times.
The menu returns to the LOCAL mode.
SETUP
SELECT :
TY PE . 1
T YPE1
MED I A COMP. <ent >
T YPE1
PR I NT MODE<ent >
T YPE1 MODE
RET . SPD UP <e n t>
T YPE1 MODE
QUA L I TY<ent >
<< LOCA L> >
width:1272mm
T YPE1 MODE
RET . SPD UP : ON
T YPE1 MODE
RET . SPD UP : OFF
T YPE1 MODE
RET . SPD UP <e n t>