Instruction manual

- vi -
Relationship between image quality and printing speed [QUALITY] .............................. 3.8
Printing direction [DIRECTION] ...................................................................................... 3.9
Returning speed up [RET. SPD UP] ............................................................................. 3.10
Improving the density of ink color [INK LAYERS] ................................................... 3.11
Setting the ink drying time [DRYING TIME] ........................................................... 3.12
Deciding the priority of settings by the computer or the plotter [PRIORITY] .......... 3.13
Increasing (decreasing) the right and left margins of the fabric [RIGHTmargin]/
[LEFTmargin] ......................................................................................................... 3.15
Setting [RIGHTmargin] .................................................................................................. 3.15
Setting [LEFTmargin] .................................................................................................... 3.16
When using the plotter in an extremely dusty or dry place [REFRESH] ................ 3.17
Setting a unit of length displayed on the LCD [MM/INCH] ..................................... 3.18
Setting the type of ink to be used [INK TYPE] ....................................................... 3.19
Setting up auto-cleaning function [AUTO CLEAN]..................................................3.20
Setting up auto-cleaning function [AUTO CLEAN2] ............................................... 3.21
Back feed Setting for End of printing [EndOf PRINT] ............................................ 3.23
Continuing printing after [Ink Near End] [PRINT CONT.] ...................................... 3.24
Preventing the fabric skew [CENTERING]............................................................ 3.25
Enabling the take-up unit [TAKE-UP] ..................................................................... 3.26
Resetting printing conditions by type [SETUP RESET] ......................................... 3.27
Chapter 4 Maintenance functions
Maintenance of the printer ....................................................................................... 4.2
Function menu [MAINTENANCE] ................................................................................... 4.2
Before starting maintenance .................................................................................... 4.3
Checking the menu mode ............................................................................................... 4.3
Invoking a maintenance function .................................................................................... 4.3
Maintenance functions ............................................................................................. 4.4
Drawing setup conditions [LIST] ..................................................................................... 4.4
Printing HEX code of printing command [DATA DUMP] ................................................. 4.5
Correcting the dot positions after adjusting the head height [PRINTadjust] .................... 4.6
Moving the carriage to clean the station interior [CARRIAGEout] .................................. 4.8
If a defective printing is not corrected even after the cleaning function is executed ....... 4.9
Periodical cleaning of the wiper .................................................................................... 4.10
Notes on handling the wipers........................................................................................ 4.10
When the message [Replace Wiper] is displayed [WIPER EXCHG] ............................ 4.11
When the message [Clean Wiper Shaft] is displayed ................................................... 4.13
Cleaning the nozzle [NOZZLE CLN] ............................................................................. 4.14
Ink discharge way cleaning [DRAIN WASH] ................................................................. 4.17