Instruction manual

- 1.44 -
9. Pull out the leading edge of the fabric from the
front face of the printer.
• Open the front cover, move up the clamp level
while holding the leading edge of the fabric
with your hand, then pull out the fabric.
10. Rewind the roll holder or fabric core several times
from the rear face of the printer.
Make the fabric slack to alleviate the tension of the fabric.
• Do not pull the fabric directly, as this may
cause wavy portion of the fabric.
11.Move down the clamp lever on the front face of
theprinter.
Secure the roll fabric pulled out to the front face, using the pinch
roller.