Instruction manual

- 1.40 -
Setting the mating sheet
The mating sheet is used to prevent ink penetration of the fabric which is not dried after
printing.
1. Set the fabric core of the slip sheet to the slip
sheet bar hanger.
Adjusting parallelism of loading unit
If the parallelism of the loading unit is remarkably broken, the fabric deviation or wrinkle may
occur. In this case, adjust the parallelism of the loading unit.
1. Fasten the screw which secure the loading unit
to the printer.
2. Adjust the position of the loading unit on the side
of fabric deviation or wrinkle occurrence so that
it be apart from the printer, then secure it with a
screw.
3. Clamp the fabric again and then start printing.
• Note that fabric deviation may occur if the width is adjusted too large.