Instruction manual
- 1.28 -
Front cover and maintenance cover
Opening/closing the cover
Do not open the front cover and the maintenance cover while the printer is in operation.
If you open the front cover or the maintenance cover during printing, the carriage will stop for
safety, reselting in abortion of printing. In this case, re-start the printer and computer following
the procedure described below.
Keep the front cover and maintenance cover closed regardless during printing operation or
not. Otherwise it cause the dust attach to the head nozzle.
Do not open the maintenance cover except when it is necessary to clean the station interior.
When opening the cover during printing
If you open the front cover or the maintenance cover during printing, operate the following
steps:
STEPS:
1. When opening the cover during printing, the mes-
sage shown on the right will be displayed.
2. After the completion of data transmission from
the computer, close the cover, then press the [EN-
TER] key.
• If the data transmission from the computer
cannot be stopped, first switch off the power
supply of the computer then switch it on to
restart the computer.
The carriage will start to move.
The carriage will carry out as same as after turning on the power
of printer.
Close The Cover
PRESS<ENT>KEY