Instruction manual

- 1.13 -

Configuration and Fnction

Front face

Name Function

1. Front cover It is opened when setting fabric or taking a corrective measure against a

fabric jam.

2. Parallel connector Bi-directional parallel interface connector (complies with IEEE1284)

3. IEEE1394 connector 400Mbps interface connector compatible with IEEE1394.

4. AC inlet The power cable is connected to the AC inlet.

5. Power switch It turns on/off the power to the printer.

6. Operation panel This panel has the operation keys required for operating the printer and

the LCD for displaying set items, etc.

7. Maintenance cover This is the station cover. During maintenance of the station (See page

4.8), open it by loosening the screws.

8. Waste ink hose Waste ink hose

9. Stand It supports the main unit. It is provided with casters that are used to

move the printer.

10. Take-up device It supports to wind up the roll fabric printed, and have the operation

named FORWARD / OFF / REVERSE.

11. Clamp lever It is made to go up-down the pinch roller for holding fabric.

12. Platen It puts out the fabric as it is printed on.

13. Take-up auxiliary bar This shaft guides the printed fabric to the take-up printer.