Instruction manual

- 1.9 -
9. Connect the cable of take-up device into the con-
nector located at the left bottom of the main unit.
Attaching take-up auxiliary bar
Align the screw hole of the take-up auxiliary bar
with the screw hole on the front face of the stand,
then fasten the screws.
Attaching loading auxiliary bar
Align the screw hole of the take-up auxiliary bar
with the screw hole on the front face of the stand,
then fasten the screws.
Set a Take-up support bar on the front of the machine with a
indication see at the right side of it.
seal
chamfer