Instruction manual

- 5.9 -
The printer has failed to detect
the fabric.
The printer has failed to detect
the origin.
The take-up unit error has
been occured because of
sensor error.
The centering unit error has
been occured. The centering
unit has not been connected
properly.
01: Sensor NONE
02: Unit NONE
Error message Cause Corrective measure
Both edges of the set cloth are
not positioned properly.
If an error is displayed after set-
ting it properly, contact your
dealer or MIMAKI sales office.
Turn off the power to the printer
and turn it on after a while. If the
same error message appears
again on the LCD, contact your
local distributor to call for service.
Check the connection.
Turn off the power to the printer
and check the connection of the
cable of the take-up unit. When
the same error message appears
again on the LCD even if the
cable is connected properly, con-
tact your local distributor to call
for service.
Turn off the power to the printer
and check the connection of the
cable of the centering unit. When
the same error message appears
again on the LCD even if the
cable is connected properly, con-
tact your local distributor to call
for service.
ERROR 5 0
ME D I A S E N SE
ERROR 5 1
YORIGIN
ERROR 6 0
TAKE - UP UN I T
ERROR 6 2
CENTERING U N IT n