Instruction manual

- 4.12 -
7. Holding the projections at both ends, insert a
new wiper into place.
•Do not touch the rubber portion of a new
wiper. It can cause the nozzle to be clogged.
• Insert the wiper so that its felt side surface is
placecd on the left as viewed fromyour position.
8. Clean the wiper guide shaft using a swab or cloth.
(If dirt is hard to remove, use a swab of cloth damepened with
water.)
• Extremely dirty wiper guide shaft may cause
operation failure of the wiper, resulting in er-
ror display.
9. Close the maintenance cover, then press the
[ENTER] key.
The menu enters the LOCAL mode.
<< LOCA L> >
width:1272mm
INTIALIZING
PLEASE WAI T