Instruction manual

- 3.26 -
Enabling the take-up unit [TAKE-UP]
This function enables the take-up unit.
INTERVAL : Take-up operation is performed according to the slack sensor.
When Interval is selected, wrinkles at platen are less occurs and printing
is stable.
On the other hand, take-up is not well performeed, because take-up thick-
ness at right and left side differs, so that take-up of roll may not complete.
ON : Take-up operation is performed with taking up the fabric continuousely
instead of using the slack sensor.
Wrinkes at platen tend to occur. Adjustment of torque limitter intensity is
frequently required.
OFF : Does not enable the take-up unit.
• Operates according to slack and limit sensor.
• In case Leaf is selected for the fabric used, the take-up unit is not enabled.
STEPS:
1. Select a type. (See page 3.3)
Here, select [Type.1].
2. Press the [ENTER] key.
3. Press the JOG keys [
] and [ ] to select
[TAKE-UP].
4. Press the [ENTER] key.
5. Press the JOG keys [
] and [ ] to select [IN-
TERVAL], [ON] or [OFF] of the [TAKE-UP].
Here, select [ON].
6. Press the [ENTER] key.
7. Press the [END] key twice.
The menu returns to the LOCAL mode.
SETUP
SELECT :
TY PE . 1
T YPE1
MED I A COMP. <ent >
T YPE1
T AKE -UP <ent>
<< LOCA L> >
width:1272mm
T YPE1
T AKE -UP
:OFF
T YPE1
T AKE -UP
:ON
T YPE1
T AKE -UP <ent>