Instruction manual

- 3.23 -
Back feed Setting for End of printing [EndOf PRINT]
This function sets the operation when printing completes.
If back feed is set to ON, eliminate the waste space on media by feeding back the media .
ON : Media back feed is performed by setup value(1 to 60mm).
OFF : Media back feed is not performed.
• Before setting up the back feed value, confirm the distance between the
data. If backfeed distance is larger than the distance between data, print is
overlapped on printed data.
• When media back feed is set to ON, wrinkle may occurs on media.
STEPS:
1. Select a type. (See page 3.3)
Here, select [Type.1].
2. Press the [ENTER] key.
3. Press the JOG keys [
] and [ ] to select
[EndOf PRINT].
4. Press the [ENTER] key.
5. Press the JOG keys [ ] and [ ] to select [ON] or
[OFF] of the [BACK FEED].
Here, select [ON].
6. Press the [ENTER] key.
7. Press the JOG keys [
] and [ ] to select the
back feed distance.
select the value among 1 to 60mm
8. Press the [ENTER] key.
9. Press the [END] key twice.
The menu returns to the LOCAL mode.
SETUP
SELECT :
TY PE . 1
TYPE1 E n d O f P r n
B A C K F E E D < e n t >
TYPE1
MED I A COMP. <ent>
TYPE1 E n d O f P r n
B A C K F E E D
:OFF
TYPE1 E n d O f P r n
B A C K F E E D
=50mm
TYPE1 E n d O f P r n
B A C K F E E D
:ON
TYPE1 E n d O f P r n
B A C K F E E D
=1mm
TYPE1 E n d O f P r n
B A C K F E E D < e n t >
<< LOCA L> >
width:1272mm