Instruction manual

- 3.21 -
Setting up auto-cleaning function [AUTO CLEAN2]
Perform cleaning after when plotting specified length and prevent printing failures.
ON : The head is cleaned automatically after when plotting specified length.
OFF : The head is not cleaned automatically during plotting.
•When setting “AUTO CLEAN” ON, before starting print, remove the ink
adhered around the head . (See page 4.23)
If executing cleaning without removing the ink around the head, it may
cause the nozzle condition worse.
• The fabric that steretch with exposure to water may strech while cleaning
and color vary due to the misalignment when resume the printing.
In this case, change the setting to OFF, or change the cleaning type to [Soft]
STEPS:
1. Select a type. (See page 3.3)
Here, select [Type.1].
2. Press the [ENTER] key.
3. Press the JOG keys [
] and [ ] to select
[AUTO CLEAN2].
4. Press the [ENTER] key.
5. Press the JOG keys [ ] and [ ] to select [ON] or
[OFF] of the [AUTO CLEAN2].
Here, select [ON].
6. Press the [ENTER] key.
If selecting [ON] on step 5, the cleaning type selection screen
displays on LCD.
If selecting [OFF] on step 5, go to step 11.
7. Press the JOG keys [ ] and [ ] to select the
cleaning type.
3 types of cleaning can be selected: soft, normal, strong.
Here, select [soft].
SETUP
SELECT :
TY PE . 1
TYPE1
MED I A COMP. <ent>
TYPE1
AUTO CLEAN2 <ent>
TYPE1
AUTO CLEAN2 :OFF
TYPE1
AUTO CLEAN2 :ON
TYPE1
CLEANI NG : n ormal
TYPE1
CLEANI NG : s of t