Instruction manual

- 3.19 -
Setting the type of ink to be used [INK TYPE]
This function selects the type of ink that is to be used.
This plotter permits up to two types of ink to be loaded. When starting an actual printing
operation, however, select only one type of ink to be used according to the printing data and
the fabric used. This function can be used when different types of ink are loaded in the plotter.
As the ink that can be specified, select from the types of ink that have been set in the ink stations.
Reac : Reactive dye ink
Acid : Acid dye ink
Disp : Disperse dye ink
• If the same type of ink is set in the ink stations on both sides, the type of ink
cannot be set since [INK TYPE] is not displayed on the LCD.
STEPS:
1. Select a type. (See page 3.3)
Here, select [Type.1].
2. Press the [ENTER] key.
3. Press the JOG keys [
] and [ ] to select [INK
TYPE].
4. Press the [ENTER] key.
5. Press the JOG keys [ ] and [ ] to set a type of
ink to be used.
Here, select [Reac].
6. Press the [ENTER] key.
7. Press the [END] key twice.
The menu returns to the LOCAL mode.
SETUP
SELECT :
TY PE . 1
TYPE1
MED I A COMP. <ent>
TYPE1
INK TYPE <ent >
<< LOCA L> >
width:1272mm
TYPE1
INK TYPE <ent >
TYPE1
INK TYPE :
A c i d
TYPE1
INK TYPE :
R e a c