Instruction manual

– 4.11 –
4-3-2. HEAD ADJUST
[Function]
Plots a pattern for mechanical adjustment of position shift of each head.
(Refer to [6-2-6. Adjustment of the head] P.6-12)
[Operation]
1) Select the ADJUSTMENT.
Press the
ENTER
key.
2) Press the
FUNCTION
key to select the “HEAD
ADJUST”
Press the
ENTER
key.
3) Select the adjustment item using the
or
key.
If “SLANT adjust” has been selected )
1) Select the head (REAR / FRONT) using the
or key.
Press the
ENTER
key.
2) Select the print-type (720, 4pass / 360, 2pass)
using the
or key.
Press the
or key to change the position
(only X position) to plot.
3) Press the
ENTER
key to start drawing.
FUNCTION
# ADJUST < ENT >
# ADJUST
HEAD ADJUST < ent >
#HEAD ADJUST
SLANT adjust < ent >
#HEAD ADJUST
R/F HEAD adj < ent >
#HEAD ADJUST
HEAD U/D adj < ent >
#HEAD ADJUST
SELECT : REAR
#HEAD ADJUST
TYPE : 720 4pass
#HEAD ADJUST
PRINT START : ent