Instruction manual

– 6.8 –

3) Press the

key to enter the flashing mode.

Set Shot to 5000000 (maximum value) and then press the

key. Flashing operation

is performed on the Cap automatically.

4) Press the plain paper with your hand to make a mark of the Cap and then remove it.

If the gap between the Cap and flashing is 0.5mm or more, the result is OK; otherwise, re-

adjust the forward and backward position of the Cap.

0.5mm or more

1. Return the head

to on cap.

2. Flashing 3. Move the head

on platen.