Instruction manual

– 6.5 –

2. Operation adjustment

The Capping position adjustment operation is serialized as follows:

When the cam is oriented

to the bottom, the Cap is

at the bottom position.

# ADJUST

CAPPING < ent >

HEAD height

LOW ?< > YES

Make sure that the head is at the bottom position and

then select [>Yes].

1. Bottom position of Cap

(adjustment value = 250 to 380)

If the Cap is removed, check the station sensor and

station belt (cam phase).

2. Cap Y

3. Capping height

(adjustment value = 1.0 to 2.2)

If the Cap is removed, check the station sensor and

station belt.

4. Wiping Y

5. Wiping height (adjustment value = 3.2 to 4.2)

1. Bottom point of Cap

Adjust the bottom position of Cap, using the

or key.

# ADJUST

LOWER POS. = ∗ ∗ ∗

# ADJUST

CAP POS. = ∗ . ∗

# ADJUST

CAP HEIGHT = ∗ . ∗

# ADJUST

WIPER POS. = ∗ . ∗

# ADJUST

WIPER height = ∗ . ∗