Specifications

3 Printing
3-30
5 Press the [] or [] key to correct the dot position of pattern 1.
Select the correct dot position on [PATTERN 1] using the JOG key [] or [].
Select the dot position where the dots of outward trip and those of homeward trip form a straight line on the test
pattern.
6 Press the [ENTER] key.
7 Subsequently repeat Steps 5 and 6 three times to correct the dot positions on Pattern
2 to Pattern 4.
Select the correct dot position on each of the patterns.
Enter the dot position correction values on Patterns 1 to 4 and then terminate dot position correction.
8 Press the [END] key several times.
The printer returns to LOCAL mode.
 If no correction value for straight line pattern is found within the range from -40
to +40, adjust the head height and then execute the [DROP.POScorrect] func-
tion again.
Input COMP value.
-40.0 - +40.0
DROP.POScorrect
PATTERN1 = 0.0
Input range:
Patterns 1 to 4
-40.0 to 40.0
Output direction
The dots at the fourth position counted
from the zero position in the positive
direction form a straight line.
In this case, the dot position correction
value is 4.0.
Input COMP value.
-40.0 - +40.0
DROP.POScorrect
PATTERN2 = 0.0
Input range:
Patterns 1 to 4
-40.0 to 40.0
L. ∗ >
width : ∗∗∗∗ mm