Specifications

3-25
Checking for nozzle clogging, and unclogging nozzles
If nozzles cannot be unclogged [FILL UP INK]
Execute the [FILL UP INK] function when the blocked nozzles are not unclogged even by executing head
cleaning (See 3-23) and nozzle washing (Refer to “Cleaning the nozzle [NOZZLE WASH] (p.4-
10)” ).
STEPS:
1 Make sure that the printer is in LOCAL mode, and then select [MAINTENANCE] using
the [FUNCTION] key and press the [ENTER] key.
If it is in REMOTE mode, press the [REMOTE] key.
2 Select [HD.MAINTENANCE] by pressing the [] key Twice and press the [ENTER]
key.
3 Press the [ENTER] key, select the heads to be cleaned using the [], [], [] or []
key, and press the [ENTER] key.
Select a set of Heads 1 and 2 or Heads 3 and 4.
 If there is a problem with the waste ink tank, the display will show either of the
following messages.
Follow the displayed instructions to restore the normal conditions.
FUNCTION
MAINTENANCE <ENT>
L. ∗ >
width : ∗∗∗∗ mm
MAINTENANCE
HD.MAINTENANCE <ent>
MAINTENANCE
ST.MAINTENANCE <ent>
Twice
FILL UP INK
HEAD SELECT : 12. 34
HD.MAINTENANCE
FILL UP INK <ent>
No waste ink tank,
or a tank is FULL.
<ENT>keyHIT is after
theTANK set or exchg
Replace a
waste ink tank.
<ENT>keyHIT is after
the TANK exchange.