Specifications

3-3

Turning the power on

Turn the power on.

STEPS:

1 Turn on the power to the printer.

Press the power switch located on the front of the printer once.

When the power is turned on, the LCD panel displays [BOOT] first and then displays the firmware version

number.

2 The message [PLEASE WAIT] appears flashing.

The printer performs initial operation.

3 The printer enters the LOCAL mode.

If media has been set on the printer, the media select display appears.

4 On making sure that the display shown below has appeared, turn on the power to the

computer that is connected to the printer.

 Make sure that the front cover and maintenance covers are all closed. If any of

the covers is open, the printer does not start up properly.

BOOT

∗Being Initialized∗

NOT POW-OFF !!

XXX-XXXX V ∗.∗∗

PLEASE WAIT

L. ∗ >

MEDIA SELECT

ROLL < > LEAF