Specifications
2-31
About Function Menus
ROUTINE SETUP ROUTINE WIP-
ING (p. 4-33)
[
Only when solvent
ink is used.
]
SCAN COUNT 0 to 9990 times With the power turned on, the
printer performs various operations
at fixed intervals to prevent such
trouble as nozzle clogging, nozzle
missing, ink drops falling or ink
spraying. Set the number of times
scanning can be performed before
the nozzle surface wiping operation
is to be performed to remove con-
densation.
TEMP.difference 1 to 60°C (In units having been set
by [MACHINE SET] function)
Set the value of a difference in tem-
perature between the print heater
and the ambient temperature at
which wiping operation is to be per-
formed.
REFRESH
(p. 4-35)
REFRESHinter-
val
OFF, 1 to 168 h Set the interval (in hours) at which
refreshing operation is to be per-
formed.
TUBE WASH
(p. 4-37)
WASH INTER-
VA L
OFF, 1 to 168 h Set the interval (in hours) at which
pump tube cleaning operation is to
be performed.
CLEANING
(p. 4-38)
CLEAN. INTER-
VA L
OFF, 1 to 168 h Set the interval (in hours) at which
cleaning operation is to be per-
formed.
CLEAN. TYPE Normal, Soft, Hard Set a type of cleaning.
Sub-INK WARNING
(p. 4-55)
[Only when dedicated sublimation trans-
fer ink is used.]
OFF, 12 to 120 h Set the interval (in hours) at which
cleaning operation is to be per-
formed to prevent color change
because this machine has been left
and color material has settled.
WIPER LEVEL (p. 4-40) 10/10 to 1/10 The wipers are consumables. The
heads can get dirty easily in a dusty
atmosphere.
The heads cannot be cleaned ade-
quately with curled or worn wipers.
This printer gives the wiper replace-
ment warning earlier than standard
depending on the operating environ-
ment. (10/10 = Default)
HEAD SELECT (p. 5-10) [1234]
[123–] , [–234]
[12––] , [–23–] , [––34]
[1–––] , [–2––] , [––3–] , [–––4]
Select the head(s) to be used for
printing.
Any of the combinations of heads
shown at left is available.
MEDIA RESIDUAL (p. 6-14) ON, OFF Set ON/OFF of the media remaining
amount display function.
Input the media length (initial value
of remaining amount ) when the roll
media is detected.
BeforeMovingIt. (p. 6-15) Use this function to lock the station
when the printer is to be transported.
Function name Sub function Setting value Function